Surveon CAM12 Series, User Manual, Page: 63 / 146

63
Network Configuration
These settings are used to configure basic network access for the camera.
They are found under Network> Network Configuration .
Most of these settings vary with your specific hardware setup; therefore the
defaults are set for common SOHO level usage. If you are using the camera in
an enterprise environment, please check with your IT department to
determine the correct settings for this section.
IP & DNS Settings
These settings are used determine the IP address of the network camera.

Get IP address automatically
-
Automatically acquires IP address from
a DHCP service. This is the default setting .

Use fixed IP address
-
Sets a fixed IP address. You must also manually
fill in IP address, Subnet mask, Default gateway, Primary DNS, and
Secondary DNS fields. The network camera can be connected to the
network upon completion.
IPV6 & DNS Settings
This only works if your network environment and hardware equipment
support IPv6.

Get IPv6 address automatically – the network camera will listen to
router advertisements and be assigned with a link-local IPv6 address
accordingly.

Use fixed IPv6 address - Sets a fixed IPv6 address. You must also
manually fill in IP address, Prefix length, Default gateway, Primary
DNS, and Secondary DNS fields. The network camera can be connected
to the network upon completion.
PPPoE Settings
This feature is disabled by default. Connecting to the network using PPPoE
(Point-to-Point Protocol over Ethernet) requires a user name and password
from your ISP (Internet Service Provider). Select Enable PPPoE and fill in
valid user name and password to connect the camera to the Internet.