Surveon CAM12 Series, User Manual, Page: 112 / 146

112
Reset to Factory Default Settings
To reset the device to the factory default settings:
1. Make sure the device is in operation mode.
2. Using a needle or similar object to press and hold the Reset button until
the camera restarts (about 2 seconds). The status LED will change to
amber during startup.
3. When the Status Indicator changes to back to Green (which may take up
to 1 minute), the process is complete. The default IP address is
192.168.88.10 if not assigned by a DHCP server.
Note: Resetting to the factory default settings using the Reset button will
cause all parameters (including the IP address) to be reset. To reset
the unit without changing parameters, disconnect and reconnect the
power connector.
Camera resets can also be performed under System> Reset To Factory
Default.
There are 2 types of reset.
 Reset All Configurations to Factory Defaults

Reset All Configurations to Factory Defaults Except Network
Configuration.
Alternately, you may press the “Reset” button on the bottom of the camera
to perform a complete reset of the camera (no configurations retained). To
reset the camera by pressing the “Reset” button on the bottom of the
camera, press and hold the “Reset” button for 3 seconds. During this time,
the LED indicator in front of the camera will blink in red.