Surveon CAM12 Series, User Manual, Page: 33 / 146

33
1. Audio In/Out
Audio In/Out are both for 3.5mm jacks. Audio In provides for an
external mono microphone. Audio Out can be connected to a public
address system or an active speaker with a built-in amplifier. A pair
of headphones can also be attached.
2. Status LED indicator
The LED will light up after the camera has successfully completed
the boot process. The Status LED indicator in the rear of the camera
can be set to light whenever the unit is accessed, or be shut off.
Status
LED
(rear)
Green
Shows steady green for normal operation, flashing
when the camera is accessed.
Note: The Status LED can be configured to be unlit.
Amber
Steady during startup, reset to factory default or
when restoring settings.
Flashes every 0.2 sec during firmware upgrade.
(On:0.2 sec, Off: 0.2 sec)
Note: Startup or reboot may have failed if the status LED shows
steady amber for over 1 minute.
Unlit No network connection.
3. Reset Button
Pressing the reset button will restore the camera to its factory
default settings, as described in Resetting to the Factory Default
Settings.
Note: Camera resets can also be performed under System > Reset To Factory
Default on the web interface .
4. Network Connector
The camera connects to the network via a standard RJ-45 network
connector. The camera detects the speed of the local network
(10/100BaseT). The camera also supports PoE (Power-over-Ethernet),
and can be powered directly through the network cable.
5. Power Connector
The power connector is provided for solutions without PoE.