396
-
3815Y1 SureFire PumpRight for Raven RCM
46
Revised 12/04/2019
(The SureFire hydraulic pump with an RPM
Sensor is 15 pulses/rev as shown above.
These instructions do not cover every possible setup. Your setup may
be different. See the
information and complete setup and operating instructions.
SureFire harnesses for the Raven RCM are designed for specific
operating setups. Pinouts on the Raven RCM change depending on
the Profile Setup and the number of products. See the wiring harness
diagram for your harness.
More information is available at
16.
If using a Pump RPM sensor on a SureFire PumpRight Hydraulic Pump
Select
Voltage
-
Based
Calibration
Enter
‘
50’
Auxiliary Function Setup
If using a SureFire
Hydraulic Pump with
RPM sensor
Product 2
will be
RPM 2.
Setup instructions for Raven RCM and SureFire: 2 Liquid Products
15. Pressure Sensors
must be calibrated. See the boxes below for the procedure. Enter
50.0 mv/
PSI
for SureFire 0 to 5 volt, 0
-
100 PSI sensor.
If you have 2 sensors, both must be calibrated. Be
sure there is no pressure against the sensor when calibrating. Unplug the sensor during the calibra-
tion process.
SureFire recommends putting the Pressure Sensor reading in
your
Display Settings
on the Run Screen (see next page).
For complete information on how the sensor is operating, go to
Diagnostics > System Information > Pressure Sensors.
F
Setup &
Operation
500
Level 1
Or
Level 2
If Profile Setup will not allow you to select
a Control Valve Type, check the Unlock
Screen. If Level 1 or Level 2 is not
shown, contact SureFire to get an Activa-
tion Key for the unlock.
This requires knowing the RCM Serial
Number (on the RCM or at Diagnostics >
System Information > Hardware/Software
> Hardware Serial Number).
SureFire
Ag
Systems