Surefire iBURNER BMS-100, Installation & Operation Manual

Page: 32 / 40

32
NOTE:
If the present issue is not resolved by the above steps, please call
SureFire Technical Support @ 505-333-2876
SHUTDOWN CODES
Status Codes Symptom Action Visual
20
Solenoid Disconnected
 Pilot flame not present  System detecting a disconnect
 Check device for faulty coil
 Verify wiring from device
 Blinking Red
LED
21
Solenoid Short
 Pilot flame not present  System detecting a short
 Check device for wire short
 Verify wiring from device
 Blinking Red
LED
22
Safety T/C High
Temp. Shutdown
 Pilot flame not present  High temperature set point reached
 System detecting a disconnect upon ini-
tial start-up
 Check device for failure

Verify wiring from device
 If not using, check for jumper on input
 Blinking Red
LED
23
Safety T/C Error or
Disconnected
 Pilot flame not present  System detecting a disconnect upon ini-
tial start-up
 Check device for failure
 Verify wiring from device
 System detecting a disconnect
 If not using, check for jumper on input
 Blinking Red
LED
TROUBLESHOOTING GUIDE