Surefire iBURNER BMS-100, Installation & Operation Manual

Page: 36 / 40

36
DAUGHTER BOARD SETUP
Set High-Temperature shutdown value from T/C:
1.
Unlock the system by holding down the “status code” button for 5 seconds.
2.
Hold down the “Flame Strength” button for 5 seconds to see set-point value and press the “Status Code”
button to set high-temperature shut down value. (Default value is set to 1900°).
NOTE: The temperature will scroll quickly when button is held down. If you go past the temperature set
point continue to hold the up arrow button and the display will scroll past 2400°F and re-start at
100°F again.
Shutdown Codes
Status Codes Symptom Action
Visual
22
Safety T/C High
Temperature
 Flame reached the safety T/C
high-temperature shut down
value  Wait for T/C to cool down  Blinking Red
LED
23
Safety T/C
Error or Disconnect
 Safety T/C is damaged
 Safety T/C is not installed.
 Jumper is not installed
 Replace the Safety T/C
 Make sure that safety T/C is installed
 Verify jumper is installed (When T/C is
not is use)
 Blinking Red
LED