8
Step 1. Make sure you have positioned the booster close enough to an existing
electrical outlet.
Step 2. Make sure you have sufficient cable length between proposed outside antenna
location and booster connector.
Step 3 Make sure you have sufficient cable length between proposed inside antenna
location and booster connector.
Installation Overview
Step 1. Find the outside area that has the strongest signal.
(See page 9 for instructionif needed)
Step 2. Install the outside antenna in the area identified in step 1.
(See page 10-11 for instruction
if needed)
Step 3. Install the inside antenna.
(See page 12-13 for instruction if needed)
Step 4. Mount the signal booster, connect the outside and inside antenna cables to the signal
booster, and connect the booster to an AC power source. (
See page 14-15 for instruction
if needed)
Step 5. Configure gain settings on the signal booster if needed.
(See page 18 for instruction if
needed)
Before You Install
Outside Omni
Force5
Inside Domes
Outside Omni
FCC 27.5 (d)(4) Statement: Fixed, mobile, and portable (hand-held) stations operating in the 1710-1755 MHz band as well as mobile
and portable stations operating in the 1695-1710 MHz and 1755-1780 MHz bands are limited to 1 watt EIRP. Fixed stations operating
in the 1710-1755 MHz band are limited to a maximum antenna height of 10 meters above ground. Mobile and portable stations oper-
ating in these bands must employ a means for limiting power to the minimum necessary for successful communications.
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
