
symptom
Bike does
not turn on
Bike
powered on
but not
moving
Potential cause
Battery not plug into correct position
SoC too low
Battery enters temperature protection
Fuse
blown
Key switch not properly engaged
DC converter error
Battery malfunction
Side stand switch protection
e-brake protection
Tilt sensor was triggered but not reset
Throttle not in idle position when startup
Battery low Soc protection
Motor temperature protection
MCU temperature protection
Side stand switch error
e-brake error
Check battery plug
Charing the battery
v(-20°C to 65°C)
Check all wire and cables and replace fuse
Recheck key switch or replace new key switch
Replace DC converter
Contact manufacturer or authorized dealer
Side stand up
Check e-brake
Switch off the key switch and turn on again
after lift up the bike
Check throttle position
Charging the battery
wait until the temperature back to working
condition
wait until the temperature back to working
condition
Disconnect or replace side stand switch
Disconnect or replace e-brake
Troubleshooting
11.6
11.7
ERROR CODE
ER-106
ER-107
ER-108
ER-109
ER-110
ER-111
ER-112
ER-113
ER-114
ER-115
AL-116
AL-117
AL-118
ER-127
AL-128
ER-129
ERROR DISCRIPTION
MCU sampling error
MCU over temperature protection
(level 2)
Motor over temperature protection
(level 2)
MCU power failure protection
Battery pack Low voltage protection
(level 3)
Battery high voltage protection
Low level SOC protection (level 3)
Battery cell over/under temperature
protection (level 3)
Throttle signal protection
Throttle ground protection
High level brake protection
No.1 Low level brake protection
No.2 Low level brake protection
Motor temperature sensor error
REGEN turned OFF
CAN communication error
SOLUTION
Contact manufacturer or authorized dealer
Bike enter Low Power Mode
Bike enter Low Power Mode
Check key switch and fuse
Charging the battery pack
REGEN function disabled
Charging the battery pack
Stop using the bike and wait until the temperature back to
working condition
Check if throttle cable is short circuited or unable back to
idle position
Check if throttle cable is short circuited, cable damaged or
broken
Check if e-brake is short circuited
Check if side stand switch is still ON
Check tilt switch
Contact manufacturer or authorized dealer
Check battery temperature and battery voltage
Check all wire and cables
Troubleshooting
Troubleshooting
Summary of Contents for STORM BEE E 2022
Page 48: ...13 11 V1 0...