SUR-RON STORM BEE E 2022, Owner'S Manual, Page: 24 / 48

the motorcycle battery pack, the charger can not
charge normally.
You can directly plug the charger into the battery
charging port
' A ' on the portside of the motorcycle or
plug the charger into the charging socket B of the
removed battery pack to charge.
The charger will turn off automatically when it is
fully charged.Please disconnect the power supply of
the charger and unplug the charging plug.
When charging, please put it in a safe place
beyond reach of children.
Avoid using the battery pack when it is has just
reached full charge. It is recommended to let it cool
down for 10 minutes or longer after it is fully
charged.
It is forbidden to cover any object when charing. This
charger is for indoor use. Please use it in a dry and
well ventilated environment.
After charging, please put the rubber cap of
charging socket back on.
8.2 8.3
B
A
Power management Power management Power management
____________ Warning ____________
1 、 Always charge the battery pack in a well-ventilated
place away from any fire hazard. If you want to charge
the electric motorcycle outdoors, do not charging in the
rain or humidity condition.
2 、 The battery pack can only be charged with a special
charger supplied with the original motorcycle
manufacturer or specified by the manufacturer. The use
of unauthorized chargers or accessories may cause
damage or failure of the battery pack, or even cause
danger.
3 、 Do not charge the battery pack below 0 ℃, otherwise
it will damage the battery pack. It can only be charge
after the temperature of the battery pack rises back to
above 0 ℃. The maximum allowable charging
temperature inside the battery pack is 60 ° C. If the
internal temperature of the battery pack exceeds this
temperature, it can only be charged after cooling to
below 60 ° C. If the battery pack is discharged rapidly
due to heavy duty riding, the internal temperature of
the battery pack may still be higher than 60 ° C even if
the ambient temperature is low.
4 、 The battery pack is only allowed to return to normal
temperature by itself. Do not use other methods to raise
high-pressure water pump, let alone immerse the
battery pack in water. The wading of the whole
motorcycle should not exceed the center of the
wheel, otherwise it may cause water ingress in the
battery pack, internal short circuit and permanent
failure of the battery pack.
If water ingressed in to battery pack or battery pack
had other issues, it is strictly forbidden to charge the
whole motorcycle or battery pack again. It may
cause the risk of fire, combustion and explosion of
the battery pack.
The battery pack is water resistant and sealed with a
high voltage circuit inside. If the exernal structure is
damaged this will reduce the water-resistant
performance of the battery pack. If the water-
resistant structure is damaged, please contact the
after-sales service. It is strictly forbidden for
customers to disassemble the battery pack, to avoid
potential damage and serious danger.
Power supply and charging
Before charging, please check whether the input
voltage range of the charger is consistent with the
grid voltage, AC 95 ~ 125V / 190 ~ 250V.
Before charging, please check whether the load
power of AC power network socket can meet the
power requirements of charger.
When charging, please connect the battery pack
first, and then connect the AC power input plug. If
you plug in the AC power first and then connect to