Chapter 4: BIOS
4-15
Mark DMI Events as Read
This setting allows you to mark DMI events as read.
Clear all DMI Event Logs
Setting this option to Yes will clear the DMI event log before rebooting. The options
are Yes and
No.
Console Redirection
Access the submenu to make changes to the following settings:
COM Port Address
This setting will allow you to specify which COM port to direct the remote console
to: Onboard COM A or Onboard COM B. The options are Onboard COM A, On-
board COM B and
Disabled
. Note: If an IPMI device is installed, the default value
is
On-board COM B
.
Baud Rate
This setting will enable you to set the baud rate for the console redirection. The
options are 300,1200, 2400, 9600,
19.2 K
, 38.4K, 57.6K, and 115.2K.
Console Type
This setting will enable you to set the console redirection type. The options are
VT100, VT100 (8bit), PC-ANSI (7bit),
PC ANSI
, VT100+, VT-UTF8 and ASCII.
Flow Control
This setting enables you to select the flow control option for the console. The op
-
tions are: None, XON/XOFF, and
CTS/RTS.
Console Connection
This setting allows you to decide how the console redirection is to be connected.
The options are
Direct
or Via Modem.
Continue CR after Post
This setting allows you to decide if you would like to continue with the console
redirection after the POST routine. The options are On and
Off.
Hardware Monitoring
Highlight this and press <Enter> to see the status of each of the following items:
Summary of Contents for X7SBU
