Supero X7SBU, User Manual

Page: 58 / 89

4-4
X7SBU User's Manual
Hard Disk Pre-Delay
This setting allows the user to add a delay prior to the first access of a hard disk by
the BIOS. The delay ensures that the hard disk has time to initialize before power
up. The options are3, 6, 9, 12, 15, 21, 30 seconds and
Disabled
Serial ATA
This setting allows you to enable or disable the function of the Serial ATA. The
options are Disabled and
Enabled.
Native Mode Operation
Select Serial ATA for SATA or select Auto (Native Mode) for ATA. The options are:
Serial ATA and
Auto.
Note: Auto may cause Linux to recognize SATA hard drives as IDE drives
SATA RAID Enable
This setting allows you to enable or disable the SATA RAID functionality. The op-
tions are
Disabled and Enabled.
ICH RAID Code Base
Select Intel to enable the Intel SATA RAID firmware. Select Adaptec to use the
Adaptec HostRAID firmware. The options are
Intel and Adaptec .
SATA AHCI Enable
Enhanced AHCI: WinXP-SPI + IAA driver supports AHCI mode. The options are
Disabled and Enabled.
SATA AHCI Legacy Enable (This appears if SATA AHCI Enable above is set
to Enabled)
Select Enable to use Legacy Mode for SATA Advanced Host Interfacing. When
this feature is set to Enabled, SATA Port 5 and SATA Port 6 are disabled. (Take
caution when using this function. This feature is for advanced programmers only.)
The options are Enabled and
Disabled .

SATA Port 0, SATA Port 1, SATA Port 2, SATA Port 3, SATA Port
4, and SATA Port 5, Ext. Primary Master, Ext. Primary Slave
Extended Primary Master/Slave
These settings allow the user to set the parameters of IDE Primary Master/Slave,
IDE Secondary Master/Slave, SATA Port3/SATA Port4 and Extended Primary
Master/Slave slots. Hit <Enter> to activate the following sub-menu screen for