Supero SuperServer 6041G, User Manual

Page: 25 / 114

Chapter 2: Server Installation
2-9
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SCA
drives and backplane have been properly installed and all connections have
been made.
1. Accessing the drive bays
All drives can be accessed from the front of the server. For servicing
the CD-ROM and floppy drives, you will need to remove the top
chassis cover. The SCSI disk drives can be installed and removed
from the front of the chassis without removing the top chassis cover.
2. Install a CD-ROM and floppy disk drives
Refer to Section 6-4 if you need to reinstall a CD-ROM and/or floppy
disk drive to the system.
3. Check the SCSI disk drives
Depending upon your system's configuration, your system may have
some SCSI drives already installed. If you need to install SCSI drives,
please refer to Section 6-4.
4. Check the airflow
Airflow is provided by four hot-swap input fans and one exhaust fan,
all of which are 9-cm in size. An air shroud has been installed to
direct sufficient cooling air to the processors, which generate the most
heat. Also note that all power and data cables have been routed in
such a way that they do not block the airflow generated by the fans.
5. Supply power to the system
The last thing you must do is supply power to the system. Plug two or
all three power cords from the two power supply units into a high-
quality power strip that offers protection from electrical noise and
power surges. It is recommended that you use an uninterruptible
power supply (UPS).