Supero SUPERSERVER 6027R-N3RF, User Manual

Page: 13 / 130

Chapter 1: Introduction
1-3
Onboard Controllers/Ports
The color-coded I/O ports on the X9DRW-3F/iF include two COM ports (one header
and one port), a VGA (monitor) port, six USB 2.0 ports (4x rear, 1x header for two
front panel), two gigabit Ethernet ports and one dedicated IPMI LAN port.
Note 1: For more information on IPMI confi guration, please refer to the IPMI User's
Guide posted on our website at http://www.supermicro.com/support/manuals/
Graphics Controller
The X9DRW-3F/iF features an integrated Renesas Base-board Controller (BMC)
chip, which also acts as a video controller.
Other Features
Other onboard features that promote system health include onboard voltage
monitors, auto-switching voltage regulators, chassis and CPU overheat sensors,
power management, AC power loss recovery, virus protection and BIOS rescue.
1-3 Server Chassis Features
The SuperServer 6027R-N3RF/WRF is built upon the SC825TQ-R740WB chassis.
Details on the chassis and on servicing procedures can be found in Chapter 6. The
following is a general outline of the main features of the chassis.
System Power
The SC825TQ-R740WB features a redundant 740 Watt power supply consisting of
two power modules. The system does not need to be shut down when replacing or
removing a single power supply module.
Hard Drive Subsystem
The SC825TQ-R740WB chassis was designed to support eight hot-swap SATA
or SAS hard drives.
PCI Expansion Slots
A riser card (RSC-R2UW-4E8-O-P) on the left side of the chassis can support an
add-on card. See our web site at http://www.supermicro.com/products/nfo/UIO.cfm
and Section 5-6 for further details.