Supero SUPERSERVER 5015M-MF, User Manual

Page: 65 / 120

Chapter 6: Advanced Chassis Setup
6-5
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
CD-ROM/Serial ATA Drives: For installing or removing the CD-ROM or Serial ATA
drive, you will need to gain access to the inside of the server by removing the top
cover of the chassis. Note that the 5015M-MF(+) does not include a CD-ROM
drive.
Note: Only a "slim" CD-ROM will fi t in the 5015M-MR(+).
Serial ATA Drive Installation
The SATA drive is not hot-swappable, meaning system power must be turned off
before installing or removing.
To install or remove the drive, fi rst power down the system and then remove the
top cover of the chassis as described on page 6-7. Unscrew the retention screw
at the top center of the drive, then push the drive tray out from the back until you
can grasp and pull it out through the front of the chassis. Remove the drive from
the drive tray.
To add a new SATA drive, install a drive into the tray with the printed circuit board
side facing down and so that the mounting holes align with those in the tray. Secure
the drive to the tray with the four screws. Replace the top cover when fi nished.
See Figure 6-4.
Figure 6-3b. System Cooling Fans [5015M-MF(+)]