Supero SUPERSERVER 5015M-MF, User Manual, Page: 55 / 120

Chapter 5: Advanced Motherboard Setup
5-19
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
JWD controls the Watch Dog func-
tion. Watch Dog is a system monitor
that can reboot the system when a
software application is “hung up”. Pins
1-2 will cause WD to reset the system
if an application is hung up. Pins 2-3
will generate a non-maskable interrupt
signal for the application that is hung
up. See the table on the right for jump-
er settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
in order to disable the Watch Dog Tim-
er.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Compact Flash Master/Slave
The JP3 jumper allows you to assign
either master or slave status to the
compact fl ash card, which plugs into
the J4 connector. See the table on the
right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JP3)
Jumper Setting Defi nition
Closed Master
Open Slave