Supero SUPERSERVER 1027TR-TF, User Manual

Page: 62 / 130

Chapter 5: Advanced Serverboard Setup
5-11
5-6 Installing Memory
Memory Support
Each X9DRT-F/X9DRT-IBFF/X9DRT-IBQF up to 256 GB of 240-pin Registered
(RDIMM)/Load Reduced (LRDIMM) ECC or up to 64 GB of Unbuffered (UDIMM)
ECC/Non-ECC DDR3 1600/1333/1066/800 MHz 4-channel memory in 8 slots.
Note
: Check the Supermicro web site for recommended DIMMs and memory
updates.
Installing Memory Modules
1. Insert each memory module vertically into a slot following the charts below.
Pay attention to the notch along the bottom of the module to prevent inserting
it incorrectly.
2. Gently press down on the DIMM module until it snaps into place in the slot
(see Figure 5-3).
3. Repeat for all DIMMs. See tables below and on following pages.
CAUTION! Exercise extreme care when installing or removing
DIMM modules to prevent any possible damage.
Processors and their Corresponding
Memory Modules
CPU# Corresponding DIMM Modules
CPU 1 P1-
DIMMA1
P1-
DIMMB1
P1-
DIMMC1
P1-
DIMMD1
CPU2 P2-
DIMME1
P2-
DIMMF1
P2-
DIMMG1
P2-
DIMMH1
Processor and Memory Module Population for Optimal Performance
Number of
CPUs+DIMMs
CPU and Memory Population Configuration Table
(For memory to work properly, follow the instructions below.)
1 CPU &
2 DIMMs
CPU1
P1-DIMMA1/P1-DIMMB1
1 CPU &
4 DIMMs
CPU1
P1-DIMMA1/P1-DIMMB1, P1-DIMMC1/P1-DIMMD1
2 CPUs &
4 DIMMs
CPU1 + CPU2
P1-DIMMA1/P1-DIMMB1, P2-DIMME1/P2-DIMMF1
2 CPUs &
6 DIMMs
CPU1 + CPU2
P1-DIMMA1/P1-DIMMB1/P1-DIMMC1/P1-DIMMD1, P2-DIMME1/P2-DIMMF1
2 CPUs &
8 DIMMs
CPU1 + CPU2
P1-DIMMA1/P1-DIMMB1/P1-DIMMC1/P1-DIMMD1, P2-DIMME1/P2-DIMMF1/P2-
DIMMG1/P2-DIMMH1