Supero SUPERSERVER 1027TR-TF, User Manual

Page: 10 / 130

1-2
S
UPER
S
ERVER 1027TR-TF/1027TR-TFF/1027TR-TQF User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 1027TR-TF/1027TR-TFF/1027TR-TQF lies two
X9DRT-F/X9DRT-IBFF/X9DRT-IBQF dual processor serverboards, which are based
on Intel's E5-2600 (Socket R LGA 2011) chipset. Below are the main features of
the serverboards. Note that the features on each board are doubled for the server,
which includes two nodes.
Processors
Each X9DRT-F/X9DRT-IBFF/X9DRT-IBQF supports two full-width Intel QuickPath
Interconnect (QPI) links (with Data Transfer Rate of up to 8.0 GT/s per QPI).
Please refer to our web site for a complete listing of supported processors (
www.
supermicro.com ).
Memory
Each X9DRT-F/X9DRT-IBFF/X9DRT-IBQF has 240-pin DIMM sockets that can
support up to 256 GB of registered (RDIMM)/Load Reduced (LRDIMM) ECC (192
GB for the system) or 64 GB of unbuffered ECC/Non-ECC 800/1066/1333/1600
SDRAM (256 GB for the system). See Chapter 5 Section 6 for more details on
installing memory into the system.
Onboard Serial ATA
An on-chip SATA controller is integrated into the X9DRT-F/X9DRT-IBFF/X9DRT-
IBQF to provide a six-port, SATA subsystem (two SATA 3.0 ports and four SATA
2.0 ports), which is RAID 0, 1, 5 and 10. The SATA drives are hot-swappable units.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
PCI Expansion Slots
Each X9DRT-F/X9DRT-IBFF/X9DRT-IBQF board has one PCI-E 3.0 x16 Slot
for SMC-Proprietary Riser Slot Card (available when CPU1 is installed). In the
1027TR-TF/1027TR-TFF/1027TR-TQF server configuration,riser cards have been
pre-installed to support two low-profileadd-on cards.
Ethernet Ports
An Intel® network controller is integrated into each of the serverboards to support
two Gigabit LAN ports (10BASE-T, 100BASE-TX and 1000Base-T, RJ45 output).