Supero SUPERSERVER 1018GR-T, User Manual

Page: 73 / 140

Chapter 5: Advanced Motherboard Setup
5-25
5-11 SATA Ports
SATA/SAS Connections
Ten SATA 3.0 connectors are located
on the board and support data transfer
rates of up to 6Gb/s. I-SATA 0-5 (six
connectors) are supported by the
AHCI controller and S-SATA 0-3 (four
connectors) are supported by the
sSATA controller. They support RAID
0, 1, 5, 10 although not between
controllers. See the pin definitions on
the right table.
Standby PWR LED (LED2)
LED Status
State Definition
Off System unplugged or
power supply is switched
off
On Standby Power On
Standby Power
The Standby Power LED is located
at LED2 on the motherboard. When
LED2 is on, it means that the AC
power cable is connected and the
power supply hard switch is on,
indicating that power is flowing
through the power supply and into
the motherboard. The system may or
may not be running.
UID LED Status
Color/State OS Status
Blue: On Windows OS Unit Identified
Unit Identification LED (LE1)
A rear UID LED indicator (LE1) is
located next to the I/O backplane. This
UID Indicator assists in identification
of a system. It may be triggered by
the UID switch or IPMI.
SATA/SAS Connectors
Pin Definitions
Pin# Signal
1
Ground
2 SATA_TXP
3 SATA_TXN
4 Ground
5 SATA_RXN
6 SATA_RXP
7 Ground