Supero SUPERSERVER 1018GR-T, User Manual

Page: 71 / 140

Chapter 5: Advanced Motherboard Setup
5-23
PCI Slot SMB Enable (JI2C)
Jumper Settings
Setting Definition
Short Enabled (Default)
Open Disabled
PCI Slot SMB Enable (JI2C1/JI2C2)
Use Jumpers JI2C2/JI2C3 to enable
PCI SMB (System Management
Bus) support to improve system
management for the PCI slots. See the
table on the right for jumper settings.
Watch Dog Reset
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
Pins 1-2 to reset the system if an ap-
plication hangs. Close Pins 2-3 to
generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in the BIOS.
Watch Dog (JWD)
Jumper Settings
Setting Definition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled
BMC Enable/Disable
JPB1 is used to enable or disable
the BMC (Baseboard Management
Control) chip and the onboard IPMI
port. This jumper is used together with
the IPMI settings in the BIOS. See the
table on the right for jumper settings.
BMC IPMI Enable/Disable
(JPB1) Jumper Settings
Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
LAN Port Enable/Disable (JPL1)
Jumper JPL1 enables or disables LAN
Ports 1 and 2 on the motherboard.
See the table on the right for jumper
settings. The default setting is
enabled.
LAN Enable
Jumper Settings
Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
BIOS Recovery (JBR1)
The BIOS Recovery (JBR1) is used to
enable or disable the BIOS Recovery
feature of the motherboard. Install the
jumper on pins 2-3 to begin the recovery
process.
BIOS Recovery
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal
Pins 2-3 BIOS Recovery