Supero SUPER P4QH6, User Manual

Page: 36 / 86

2-16
S
UPER P4QH8/P4QH6 User’s Manual
2-7 Jumper Settings
Explanation of
Jumpers
T o m o d i f y t h e o p e r a t i o n o f t h e
motherboard, jumpers can be used
t o c h o o s e b e t w e e n o p t i o n a l
settings. Jumpers create shorts
between two pins to change the
function of the connector. Pin 1 is
identified with a square solder pad
on the printed circuit board. See
the motherboard layout pages for
jumper locations.
N o t e : O n t w o p i n j u m p e r s ,
"Closed" means the jumper is on
and "Open" means the jumper is
off the pins.
C o n n e c t o r
P i n s
J u m p e r
C a p
Setting
Pin 1-2 short
3 2 1
3 2 1
CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this jumper consists of con-
tact pads to prevent accidentally clearing the contents of CMOS. To clear
CMOS, use a metal object such as a small screwdriver to touch both pads
at the same time to short the connection. Always remove the AC power
cord from the system before clearing CMOS.
Note: For an ATX power supply, you must completely shut down the sys-
tem, remove the AC power cord and then short JBT1 to clear CMOS. Do
not use the PW_ON connector to clear CMOS.
SCSI Termination Enable/
Disable
The SCSI Termination jumpers
allow you to enable or disable
termination for the two SCSI
channels. The normal (default)
position is open to enable SCSI
termination. See the table on the
right for jumper settings.
J u m p e r
P o s itio n
O p e n
C lo s e d
D e fin ition
E n a b le d
D is a b led
S C S I Te rm in a tio n
E n a b le/D is a b le
J u m p e r S e ttin g s
(J P A1 , J P A2 )