Supero C7B75, User Manual

Page: 78 / 97

4-14
C7B75 User’s Manual
Serial Port 1 Settings
This option specifies the base I/O port address and the Interrupt Request address of
Serial Port 1. Select Disabled to prevent the serial port from accessing any system
resources. When this option is set to Disabled, the serial port becomes unavailable.
The options are
Auto , IO=3F8h; IRQ=4; IO=3F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11,
12; and IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
Serial Port 2 Settings
This option specifies the base I/O port address and the Interrupt Request address
of Serial Port 1. The options are Auto , IO=2F8h; IRQ=3; IO=3F8h; IRQ=3, 4, 5, 6,
7, 9, 10, 11, 12; IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; IO=3E8h; IRQ=3, 4, 5,
6, 7, 9, 10, 11, 12; and IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
IT8760
Serial Port 3, Serial Port 4
Select Enabled to enable a serial port specified by the user. The options are En-
abled and Disabled.
Serial Port 3 Settings
This option specifies the base I/O port address and the Interrupt Request ad -
dress of Serial Port 3. The options are: Auto , IO=3E8h;IRQ=11; IO=3D0h;IRQ=11;
IO=3D8h;IRQ=11; IO=3E0h;IRQ=11;
Serial Port 4 Settings
This option specifies the base I/O port address and the Interrupt Request ad -
dress of Serial Port 4. The options are: Auto, IO=2E8h;IRQ=11; IO=2D0h;IRQ=11;
IO=2D8h;IRQ=11; IO=2E0h;IRQ=11;

Hardware Health Configuration
Fan Speed Control Mode
This feature allows the user to decide how the system controls the speeds of the
onboard fans. The CPU temperature and the fan speed are correlative. When the
CPU on-die temperature increases, the fan speed will also increase for effective
system cooling. Select "Full Speed" to allow the onboard fans to run at full speed
(of 100% Pulse Width Modulation Duty Cycle) for maximum cooling. This setting
is recommended for special system configuration or debugging. Select "Standard"
for the onboard fans to run at 50% of the Initial PWM Cycle in order to balance the