Chapter 6: Advanced Chassis Setup
6-7
6-5 Node
Installation/Removal
As with any server system, power must be removed from the serverboard when
upgrading or installing memory or processors. In the 2U Twin
3
server, the server-
boards (nodes) are capable of being hot-swapped from the chassis, allowing some
to be powered down for servicing while the others continue operating.
Important! Removing a node from the server affects the air
fl
ow through-
out the system. For this reason, nodes should be removed, serviced and
replaced as quickly as possible. Also note that powering down a node will
power down all the hard drives that are logically associated with it.
!
Removing a System Node
Depress the power button on the control panel to power down the node.
1.
There are two latches located below the handles at the rear of the node tray.
2.
Push both of these inward.
While pushing the latches inward, grasp both handles and pull the node from
3.
the chassis.
Perform any service needed to the node in a timely manner.
4.
Reinstall the node by pushing it into its bay until
fi
rmly seated.
5.
Summary of Contents for 2U Twin3 SuperServer 2015TA-HTRF
