Supero 2U Twin3 SuperServer 2015TA-HTRF, User Manual

Page: 39 / 94

Chapter 5: Advanced Motherboard Setup
5-5
5-5 Onboard Processor
The Intel Atom processor is soldered directly onto the motherboard. Installing and
removing the processor is not required. A small active heatsink sits on the proces-
sor to keep it cool.
5-6 Installing Memory
Note : Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
DIMM Installation
Insert the desired number of SO DIMMs into the memory slots, starting with 1.
DIMM1 then DIMM2. Insert each DIMM vertically into its slot while paying
attention to the notch along the bottom of the module to prevent incorrect
installation.
Gently press down on the DIMM module until it snaps into place in the slot. 2.
Repeat step 1 to install DIMM2 if needed. See diagrams on the following
page.
Memory Support
There are two nodes on each X7SPT-DF-D525 in the system. Each node supports
up to 4GB of unbuffered Non-ECC DDR3 SODIMMs (800MHz in two SO DIMM
slots.) Populating these DIMM slots with a pair of memory modules of the same
type and same size will result in interleaved memory, which will improve memory
performance.
Note : Refer to the Supermicro website for a list of memory modules that have been
validated with the X7SPT-DF-D525 motherboard.