20
Chapter 1: Introduction
Note 1:
For detailed instructions on how to configure Network Interface Card (NIC) settings,
please refer to the Network Interface Card Configuration User's Guide posted on the web
page under the link:
http://www.supermicro.com/support/manuals/
.
Note 2:
For detailed instructions on how to configure VROC RAID settings, please refer to
the VROC RAID Configuration User's Guide posted on the web page under the link:
www.supermicro.com/support/manuals/
.
Quick Reference Table
Jumper
Description
Default Setting
JBT1
CMOS Clear
Open (Normal)
JPME1
ME Manufacturing Recovery
Pins 1-2 (Normal)
LED
Description
Status
UID_LED1
Unit Identifier (UID) LED
Solid Blue: Unit Identified
LED2
BMC Heartbeat LED
Blinking Green: BMC Norma
Solid Greene: (during BMC Reset or a Cold Reboot)l
Connector
Description
BT1
Onboard battery
COM1
I/O COM port
FAN3, FAN4
CPU/System fan headers (FAN1 & FAN2 in the HDD backplane)
BMC_LAN1
Dedicated BMC LAN port
I-SATA 0~7 (SATA1)
Intel® PCH SATA 3.0 ports (with RAID 0, 1, 5, 10)
S-SATA 0~1, S-SATA 2~5
S-SATA 3.0 connectors supported by the Intel PCH
JNCSI
NC-SI (Network Controller Sideband Interface) connector (See Note 1 below)
JPWR1/JPWR2/JPWR3/JPWR4 6-pin power connectors
JRK1 (RAID_KEY)
Intel VROC key header for NVMe RAID (See Note 2 below)
JAIOM
AIOM (CPU1 PCIe 4.0x16) networking slot
JTPM1
Trusted Platform Module/Port 80 connector
JVGA1
VGA port
SLOT1
PCIe 4.0 x16 slot (right hand riser) supported by CPU1
SLOT2
PCIe 4.0 x16 slot (left hand riser, via cable) supported by CPU2
SXB1
PCIe 4.0 x16 slot supported by CPU2
SXB2
PCIe 4.0 x8 slot supported by CPU2
SXB3
PCIe 4.0 x16 slot supported by CPU1
SXB4
PCIe 4.0 x8 slot supported by CPU1 for SMCI-proprietary storage devices
SXB5 (S~SATA0~1)
PCIe 4.0 x8 slot supported by CPU1 for dual hybrid M.2
UID/BMC RESET (JUIDB1)
Unit Identifier (UID) & BMC Reset switch
USB0/1 (3.0)
Two USB 3.0 connectors