Supermicro SUPERSERVER 6018R-TD, User Manual

Page: 60 / 77

Chapter 7: BIOS
7-21 7-20
S
UPER
S
ERVER 6018R-TD User's Manual
sSATA Port 0-3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are
Disabled and Enabled.
Port 0-3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be con -
nected to a solid state drive or a hard disk drive. The options are Hard Disk
Drive and Solid State Drive.
*If the option "Configure sSATA as" is set to IDE, the following items will
display:
sSATA Port 0-3
This item indicates that an sSATA port specified by the user is not installed or
not detected.
Port 0-3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be con -
nected to a solid state drive or a hard disk drive. The options are Hard Disk
Drive and Solid State Drive.
*If the option "Configure sSATA as" is set to RAID, the following items will
display:
Support Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power
usage of the SATA link. The controller will put the link to a low power state when
the I/O is inactive for an extended period of time, and the power state will return
to normal when the I/O becomes active. The options are Disabled and
Enabled .
sSATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy
driver for system boot. The options are Disabled, EFI, and
Legacy .
SATA/sSATA RAID Boot Select
Select SATA Controller to boot the system from a SATA RAID device. Select
sSATA Controller to boot the system from an sSATA RAID device. Select Both to
boot the system either from a SATA RAID device or from an sSATA RAID device.
Please note that the option Both is not supported by the Windows Server 2012/
R2 OS. The options are Both, SATA Controller, and
sSATA Controller .
sSATA Port 0-3 Hot Plug
Select Enabled to support hot-plugging on the port specified by the user, which
will allow the user to replace an sSATA drive without shutting down the system.
The options are
Disabled and Enabled.
sSATA Port 0-3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are
Disabled and Enabled.
Port 0-3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be con -
nected to a solid state drive or a hard disk drive. The options are Hard Disk
Drive and Solid State Drive.

Server ME (Management Engine) Configuration
This feature displays the following system ME configuration settings.
•
Operational Firmware Version
•
Recovery Firmware Version
•
ME Firmware Features
•
ME Firmware Status #1
•
ME Firmware Status #2
•
Current State
•
Error Code

PCIe/PCI/PnP Configuration
The following PCI information will be displayed:
•
PCI Bus Driver Version
PCI Devices Common Settings:
PCI PERR/SERR Support
Select Enabled for the system to log an error event when a PERR (PCI/PCI-E Parity
Error) or a SERR (System Error) occurs. The options are
Disabled and Enabled.