Supermicro SUPERSERVER 6015V-T, User Manual

Page: 42 / 122

5-8
S
UPERSERVER 6015V-T/6015V-TLP User’s Manual
Top View of DDR2 FBD Slot
Figure 5-5a. Installing DIMM into Slot
To Install: Insert
module vertically and
press down until it
snaps into place. Pay
attention to the bot-
tom notch.
To Remove: Use your
thumbs to gently
push each release tab
outward to free the
DIMM from the slot.
DDR2 FBD DIMM
5-6 Adding PCI Cards
1. PCI slots
The 6015V-T/6015V-TLP system includes a CSE-RR1U-X riser card. This riser
fi ts into a 133/100MHz PCI-X slot to support a full-height, full-length PCI add-on
card. The 6015V-TLP can support a 133/100 MHz PCI-X or a PCI-E x8 card.
2. PCI card installation
Before installing a PCI add-on card, see step 1, above. Begin by swinging out the
release tab on the appropriate PCI slot shield. Insert the PCI card into the riser
card, pushing down with your thumbs evenly on both sides of the card. Finish by
pushing the release tab back to its original (locked) position.
Optimized DIMM Configurations
Number
of DIMMs
Bank 1 Bank 2
2 DIMMs 1A ------ ------ 2A ------ ------
4 DIMMs 1A 1B ------ 2A 2B ------
6 DIMMs 1A 1B 1C 2A 2B 2C
Notes:
1. DIMM slot# specified: DIMM slot to be
populated; “---“: DIMM slot not populated.
2. Both 667MHz and 533MHz FBD is supported;
however, you must use DIMMs of the same type
and speed (no mixing).
3. Interleaved memory is supported when pairs of
DIMM modules are installed in both Bank1 and
Bank2.
4. For memory to work properly, you need to follow
the restrictions listed above.