Supermicro SUPERSERVER 6015V-T, User Manual

Page: 65 / 122

Chapter 6: Advanced Chassis Setup
6-7
6-5 Power Supply
The 6015V-T has a single 520 watt power supply and the 6015V-TLP has a single
280 watt power supply. These power supplies have the capability of operating
at 100 or 240 input volts. Use the main power button on the front of the chassis
to power off the system and then unplug the AC power cord before removing the
power supply.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to replace
the power supply unit. Replacement units can be ordered directly from Supermicro
(see part numbers in Appendix E and contact infomation in Chapter 1).
Replacing the Power Supply
1. Accessing the inside of the SuperServer 6015V-T/6015V-TLP
To replace a power supply, you must fi rst remove the top chassis cover. To do so,
fi rst grasp the two handles on either side and pull the unit straight out until it locks
(you will hear a "click"). Next, depress the two buttons on the top of the chassis to
release the top cover and push it away from you. You can then lift the top cover
from the chassis to gain full access to the inside of the server.
2. Removing the power supply
First unplug the power cord from the system. To remove the failed power unit,
remove the two screws on the back of the power supply, which secure it to the
chassis. You can then lift the unit straight out of the chassis. (The power cord
should have already been removed.)
3. Installing a new power supply
Replace the failed unit with another unit of the same wattage. It is highly recom-
mended to replace it with the exact same power supply. Carefully insert the new
unit into position in the chassis and secure it with the two screws at the rear of
the unit. Before reconnecting the power cord, make sure the power switch on the
power supply is in the off position. Then reconnect the power cord, replace the
chassis top cover and push the unit back into the rack. Finish by turning the power
switch on the power supply on, and then depress the power button on the front of
the system.