Supermicro SUPERSERVER 6014V-T2, User Manual, Page: 53 / 120

Chapter 5: Advanced Serverboard Setup
5-17
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
JLAN1/2 Enable/Disable
Change the setting of jumper JPL1
and JPL2 to enable or disable the
JLAN1 and JLAN2 Gb Ethernet ports,
respectively. See the table on the
right for jumper settings. The default
setting is enabled
JLAN1/2 Enable/Disable
Jumper Settings (JPL1/JPL2)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
PCI Slots to SMB
Jumpers J13 and J15 allow you to con-
nect or disconnect the PCI slots to the
System Management Bus. The default
setting is closed for both jumpers to en-
able the connection. Both connectors
must be set the same (one is for data
and one is for clock). See the table on
right for pin defi nitions.
PCI Slots to SMB
Jumper Settings (J13, J15)
Jumper Setting Defi nition
Open Disabled
Closed Enabled
Alarm Reset
The system can notify you in the event
of a power supply failure. This feature
assumes that Supermicro redundant
power supply units are installed in
the chassis. If you only have a single
power supply installed, you should dis-
able this header (the default setting) to
prevent false alarms. See the table on
the right for jumper settings
Note: this jumper is not used with the
6014V-T2.
Alarm Reset
Jumper Settings (JAR)
Jumper Setting Defi nition
Open Disabled
Closed Enabled