Supermicro SUPERSERVER 6014V-T2, User Manual, Page: 43 / 120

Chapter 5: Advanced Serverboard Setup
5-7
Figure 5-5b. Top View of DDR2 Slot
Figure 5-5a. Installing DIMM into Slot
To Install: Insert module vertically and press down until it snaps into place. Pay attention
to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM
from the slot.
Note: Notches
should align
with their
receptive points
on the slot
Notch
Notch
Release
Tab
Release
Tab
5-6 Adding PCI Cards
1. PCI slots
The 6014V-T2 system includes a CSE-RR1U-X riser card. This riser fi ts into a 66
MHz PCI slot to support a full-height, half-length PCI add-on card.
2. PCI card installation
Before installing a PCI add-on card, see step 1, above. Begin by swinging out the
release tab on the appropriate PCI slot shield. Insert the PCI card into the riser
card, pushing down with your thumbs evenly on both sides of the card. Finish by
pushing the release tab back to its original (locked) position.