Supermicro SUPERSERVER 6014H-T, User Manual, Page: 52 / 124

5-18
S
UPERSERVER 6014H-T User’s Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
JLAN Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the onboard GLAN
ports (JLAN1 and JLAN2) on the
serverboard. See the table on the
right for jumper settings. The default
setting is enabled
Watch Dog Enable/Disable
JWD controls the Watch Dog func-
tion. Watch Dog is a system monitor
that can reboot the system when a
software application is “hung up”. Pins
1-2 will cause WD to reset the system
if an application is hung up. Pins 2-3
will generate a non-maskable interrupt
signal for the application that is hung
up. See the table on the right for jump-
er settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
in order to disable the Watch Dog Tim-
er.
JLAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2* Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2* Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2* Reset
Pins 2-3 NMI
Open Disabled