Supermicro SuperServer 6013P-T, User Manual, Page: 63 / 131

Chapter 6: Advanced Chassis Setup
6-5
Accessing the Drive Bays
Serial ATA Drives: Because of their hotswap capability, you do not need to
access the inside of the chassis or power down the system to install or
replace Serial ATA drives. Proceed to the next step for instructions.
CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or floppy disk
drive, you will need to gain access to the inside of the 6013P-T by removing
the top cover of the chassis. Proceed to the "CD-ROM and Floppy Drive
Installation" section later in this chapter for instructions.
Note: Only a "slim" CD-ROM drive will fit into the 6013P-T.
Figure 6-3. Removing the Front Bezel
1. Unlock
2. Press release knob
3. Remove bezel assembly