Supermicro SuperServer 6013P-T, User Manual, Page: 13 / 131

1-3
Chapter 1: Introduction
Processors
The X5DPR-TG2+ supports single or dual Intel 604/603-pin Xeon processors
of up to 3.06 GHz at a 533/400 MHz FSB. Please refer to the support
section of our web site for a complete listing of supported processors
(http://www.supermicro.com/TechSupport.htm).
Memory
The X5DPR-TG2+ has six 184-pin, DIMM slots that can support up to 12 GB
of low-profile, registered ECC DDR266/200 (PC2100/1600) SDRAM. Module
sizes of 128 MB, 256 MB, 512 MB, 1 GB and 2 GB may be used to populate
the DIMM slots. (This serverboard has has been designed to support 2GB
DIMM modules for each memory slot, but it has only been validated with 1GB
memory modules.)
Serial ATA
Two Silicon Image SATALink Sil 3112 host controllers are integrated into the
X5DPR-TG2+ to provide a four-port Serial ATA subsystem, which is RAID 0
and RAID 1 supported. The Serial ATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the
hot-swap capability and RAID function of the Serial ATA drives.
PCI Expansion Slots
The X5DPR-TG2+ has one 64-bit, 133 MHz PCI-X slot and one slim 64-bit, 66
MHz PCI slot. A "butterfly" riser card is included with the server. This riser
card fits into the 133 MHz PCI-X slot and was designed to support the use
of one standard add-on card and one low profile (half-height, half-length)
add-on card. Several jumpers on the motherboard are used to change the
speeds of these slots if needed (see Chapter 5).
ATI Graphics Controller
The X5DPR-TG2+ features an integrated ATI video controller based on the
Rage XL graphics chip. Rage XL fully supports sideband addressing and
AGP texturing. This onboard graphics package can provide a bandwidth of
up to 512 MB/sec over a 32-bit graphics memory bus.