Supermicro SuperServer 6013P-T, User Manual, Page: 55 / 131

Chapter 5: Advanced Serverboard Setup
5-19
VGA Enable/Disable
JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
S e e t h e t a b l e o n t h e r i g h t f o r
jumper settings.
Jumper
Position
1-2
2-3
Definition
Enabled
Disabled
VGA Enable/Disable
Jumper Settings
(JP4)
GLAN Enable/Disable
Change the setting of jumper JD4
to enable or disable the onboard
GLAN ports (GLAN1 and GLAN2)
on the serverboard. See the table
on the right for jumper settings.
The default setting is enabled
Jum per
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
GLAN
Enable/Disable
Jumper Settings
(JD4)
Front Side Bus Speed
JP38 is used to set the system
(front side) bus speed for the pro-
cessors. It is best to keep this
jumper set to Auto. This jumper is
used together with the CPU Ratio
Frequency setting in BIOS. See
the table on the right for jumper
settings.
Jumper
Position
Pins 1-2
Pins 2-3
Open
Definition
Auto
400 MHz
533 Mhz
Front Side Bus Speed
Jumper Settings (JP38)
Serial ATA Enable/Disable
Jumpers JPS1 and JPS2 allow you
to enable or disable the Serial ATA
headers. Jumper JPS1 is for head-
e r s S A T A # 0 a n d S A T A # 1 a n d
j u m p e r J P S 2 c o n t r o l s h e a d e r s
SATA#2 and SATA#3. The default
setting is both jumpers on pins 1-2
to enable all four headers. See the
table on the right for jumper set-
tings.
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
Serial ATA Enable/Disable
Jumper Settings
(JPS1/JPS2)