20
SuperServer 5019A-FTN10P User's Manual
Chapter 3
Component Installation and Maintenance
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and part
numbers given.
Remove power from the system and remove the top cover before installing or replacing
components. Refer to Section 3.1 and Section 3.2.
3.1 Removing Power
Use the following procedure to verify that power has been removed from the system. This
step is required when removing or installing non hot-swap components or when replacing a
non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has fully shut down, disconnect the AC power cord(s) from the power
strip or outlet. (If your system has more than one power supply, remove the AC power
cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).
3.2 Accessing the System
The SC505-203B features a removable top cover, which allows easy access to the inside of
the chassis.
Removing the Top Cover
1. Remove power from the system as described in Section 3.1.
2. Remove the screws securing the cover to the chassis (two on each side, one on the
rear).
3.
Lift the cover off the chassis.
Warning
: Except for short periods of time, do not operate the server without the cover in place.
The chassis cover must be in place to allow for proper airflow and to prevent overheating.