Supermicro SuperServer 2028BT-HTR+, User Manual

Page: 38 / 128

4-16
S
uperServer 2028BT-Hxxx User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the onboard VGA port. The default
position is on pins 1 and 2 to enable
VGA.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
JWD1 controls the Watch Dog
function. Watch Dog is a system
monitor that can reboot the system
when a software application “hangs”.
Pins 1-2 will cause WD to reset the
system if an application hangs. Pins
2-3 will generate a non-maskable
interrupt signal for the application that
has hung. Watch Dog must also be
enabled in BIOS.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable
Jumper JPB1 allows you to enable the
embedded onboard BMC (Baseboard
Management) controller to provide
IPMI 2.0 support on the motherboard.
Be sure to remove the power cord
before closing pins 2-3 to disable
the BMC.
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enable
Pins 2-3 Normal
I
2
C Bus for VRM
Jumpers JVRM1 and JVRM2 allow
the BMC or the PCH to access CPU
and memory VRM controllers.
VRM
Pin Defintions
Jumper Setting Definition
Pins 1-2 BMC (Default)
Pins 2-3 PCH