Supermicro SUPERSERVER 1028UX-LL1-B8, User Manual

Page: 67 / 74

Chapter 7: BIOS
7-37 7-36
SUPERSERVER 1028UX-LL1-B8/LL2-B8/LL3-B8 User's Manual
This item displays the Station MAC address for this computer. Mac addresses are
6 two-digit hexadecimal numbers.
Gateway IP Address
This item displays the Gateway IP address for this computer. This should be in
decimal and in dotted quad form (i.e., 192.168.10.253).
When you have completed the system configuration changes, select this option to
save the changes and reboot the computer so that the new system configuration
settings can take effect. Select Save Changes and Exit, and press <Enter>. When
the dialog box appears, asking you if you want to exit the BIOS setup without sav
-
ing, click Yes to quit BIOS without saving the changes, or click No to quit the BIOS
and save changes.
7-6 Security Settings
This menu allows the user to configure the following security settings for the
system.
Password Check
Select Setup for the system to prompt for a password at Setup. Select Always for
the system to prompt for a password at bootup and upon entering the BIOS Setup
utility. The options are
Setup and Always.
Administrator Password
Use this feature to set the administrator password which is required before entering
the BIOS setup utility. The length of the password should be from 3 characters
to 20 characters long.
User Password
Use this feature to set the user password which is required to enter the BIOS
setup utility. The length of the password should be from 3 characters to 20 char-
acters long.
7-7 Boot Settings
Use this feature to configure Boot Settings:
Boot Configuration
Setup Prompt Timeout
Use this item to indicate how many seconds the system shall wait for the BIOS setup
activation key to respond before the system starts to boot. The default setting is 1 .
Boot Mode Select
Use this item to select the type of device to be used for system boot. The options
are Legacy, UEFI, and
Dual.
Fixed Boot Order Priorities
This option prioritizes the order of bootable devices from which the system will boot.
Press <Enter> on each entry from top to bottom to select devices.