Supermicro SUPERSERVER 1028UX-LL1-B8, User Manual

Page: 32 / 74

Chapter 5: Advanced Serverboard Setup
5-5 5-4
SUPERSERVER 1028UX-LL1-B8/LL2-B8/LL3-B8 User's Manual
8. Make sure the locking mechanism
on the "Close 1st" lever catches the
lip of the load plate. Close and lock
the "Close 1st" lever.
Push down and lock the
lever labeled "Open 1st"
OPEN 1s
t
OPEN 1s
t
Push down and lock the
lever labeled "Close 1st".
9. Close and lock the "Open 1st" lever.
Engage the lip of
the load plate and
locking portion of
the lever."
7. With the "Close 1st" lever fully
retracted, gently close the load
plate.
Gently close
the load plate.
Installing a Passive CPU Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die; the required
amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are aligned
with those on the serverboard's and the heatsink bracket underneath.
3. Screw in two diagonal screws until just snug (to avoid possible damage to the
CPU do not over-tighten the screws.)
4. Finish the installation by fully tightening all four screws.
Removing the Heatsink
Caution: We do not recommend that the CPU or the heatsink be removed. However,
if you do need to uninstall the heatsink, please follow the instructions below to prevent
damage done to the CPU or the CPU socket.
1. Unscrew the heatsink screws in the sequence as shown in the illustration below.
2. Gently wriggle the heatsink to loosen it from the CPU. (Do not use excessive
force when wriggling the heatsink!)
3. Once the CPU is loosened, remove the heatsink from the CPU.
4. Remove the used thermal grease and clean the surface of the CPU and the
heatsink, Reapply the proper amount of thermal grease on the surface before
reinstalling the heatsink.