58
SuperServer 1019C-FHTN8 User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port, which is supported by the onboard BMC
controller. The default setting is Enabled.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
ME Manufacturing Mode
Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. The default setting is Normal.
Manufacturing Mode
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Normal
Pins 2-3
Manufacturing Mode
Watchdog Timer
Watchdog (JWD1) is a system monitor that can reboot the system when a software application
hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate
a non-maskable interrupt (NMI) signal for the application that hangs. The Watchdog must
also be enabled in the BIOS. The default setting is Reset.
Note:
When Watch Dog is enabled, the user needs to write their own application software
to disable it.
Watchdog
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Reset
Pins 2-3
NMI
Open
Disabled
LAN Port Enable
Change the setting of jumpers JPL1 – JPL8 for LAN1 – LAN8 to enable or disable the LAN
ports. The default setting is Enabled.
LAN Port Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
