Supermicro SuperServer 1017R-WR, User Manual

Page: 18 / 125

2-4
S
UPER
S
ERVER 1017R-WR User's Manual
2-5 Installing the System into a Rack
This section provides information on installing the system into a rack unit with the
rack rails provided.
There are a variety of rack units on the market, which may mean the assembly
procedure will differ slightly. You should also refer to the installation instructions that
came with the rack unit you are using.
Identifying the Sections of the Rack Rails
You may have received rack rail hardware with the system. (Two front inner rails
should already be attached to the chassis.) This hardware consists of two rear inner
rails that secure to the chassis, one on each side just behind the preinstalled front
inner rails. Note that these two rails are left/right specific.
Installing the Rear Inner Rails
First, locate the right rear inner rail (the rail that will be used on the right side of
the chassis when you face the front of the chassis). Align the two square holes on
the rail against the hooks on the right side of the chassis. Securely attach the rail
to the chassis with M4 flat head screws. Repeat these steps to install the left rear
inner rail to the left side of the chassis (see Figure 2-1). You will also need to attach
the rail brackets when installing into a telco rack.
Locking Tabs: Both chassis rails have a locking tab, which serves two functions.
The first is to lock the server into place when installed and pushed fully into the
rack, which is its normal position. Secondly, these tabs also lock the server in place
when fully extended from the rack. This prevents the server from coming completely
out of the rack when you pull it out for servicing.
Warning: do not pick up the server with the front handles. They are de-
signed to pull the system from a rack only.