Supermicro AS-1010P-8, User Manual

Page: 68 / 102

6-8
AS1010P-8(R)/1010P-T(R) User's Manual
6-5 Power Supply
1010P-8R/1010P-TR
The 1010P-8R/1010P-TR has a redundant 400 watt redundant power supply
confi guration consisting of two hot-swappable power modules. The power supply
modules have an auto-switching capability, which enables them to automatically
sense and operate with a 100V - 240V input voltage.
Power Supply Failure
If either of the two power supply modules fail, the other module will take the full load
and allow the system to continue operation without interruption. The Power On LED
on the control panel will turn amber and remain so until the failed module has been
replaced. Replacement modules can be ordered directly from the manufacturer.
The power supply modules have a hot-swap capability, meaning you can replace
the failed module without powering down the system.
Removing/Replacing the Power Supply
You do not need to shut down the system to replace a power supply module. The
redundant feature will keep the system up and running while you replace the failed
hot-swap module. Replace with the same model - SP400-1R (p/n PWS-0064).
1. Removing the power supply
First unplug the power cord from the failed power supply module. To remove the
failed power module, fi rst locate the colored release tab (1). Push the tab to the right
(2) and then pull the module straight out with the handle provided (3) (see Figure
6-5, single power supply server shown). The power supply wiring was designed to
detach automatically when the module is pulled from the chassis.
2. Installing a new power supply
Replace the failed hot-swap module with another SP400-1R power supply module.
Simply push the new power supply module into the power bay until you hear a click.
Finish by plugging the AC power cord back into the module.