Supermicro AS-1010P-8, User Manual

Page: 66 / 102

6-6
AS1010P-8(R)/1010P-T(R) User's Manual
SCSI/SATA Backplane
The SCSI/SATA drives plug into a backplane that provides power, drive ID and bus
termination. A RAID controller can be used with the backplane to provide data
security. The operating system you use must have RAID support to enable the
hot-swap capability of the drives. The backplane is already preconfi gured, so there
are no jumpers or switches present on it.
Figure 6-4. Removing a SCSI/SATA Drive Carrier
!
Important: All of the drive carriers must remain in the drive bays
to maintain proper cooling airfl ow.
Release Button
2. Installing/removing hot-swap SCSI/SATA drives
The SCSI/SATA drive carriers are all easily accessible at the front of the chassis.
These hard drives are hot-pluggable, meaning they can be removed and installed
without powering down the system. To remove a carrier, push the release button
located beside the drive LEDs. Then swing the colored handle fully out and use
it to pull the unit straight out (see Figure 6-4).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the SCSI drives.