Supermicro 8042-6, User Manual

Page: 64 / 114

6-2
S
UPER
S
ERVER 8042-8/8042-6 Manual
System LEDs
SCSI Drives
Figure 6-1. Chassis Front View
System Reset
Main Power
Alarm Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the serverboard to provide you with system
status and alarm indications. A ribbon cable has bundled these wires
together to simplify the connection. Connect the cable from JF1 on the
serverboard (making sure the red wire plugs into pin 1) to JP9 on the
Control Panel PCB (printed circuit board). Pull all excess cabling out of
the airflow path. The LEDs inform you of system status. See Chapter 3:
System Interface for details on the LEDs and the control panel buttons.
Figure 6-2 shows the connections, jumpers and indicators located on the
control panel PCB. Details on JF1 can be found in the Chapter 5:
Advanced Serverboard Installation.
Slim CD-ROM Drive Floppy Drive
Power Supplies
Control Panel
Rack Unit Retention
Screw (2)
Top Cover
Thumbscrew (2)
Extra Rack Unit
Retention Screw (2)
S
UPERMICR
ALARM RESET
R