FRANÇAIS
ENGLISH
9
8. Draw the nails out and position the second nail on
to the feed hook (
M, fig.5
).
9. Close cover-plate and latch (
L, fig.4
).
10. Rotate the directional exhaust deflector (
C, fig.2
),
so that the exhaust air blast will be directed away
from the operator.
USING THE TOOL
Complete all of PREPARING THE TOOL and
LOADING FASTENERS before using.
This tool can be fired in two different ways:
1.
Sequential Fire:
Push in, then turn the trigger mode selector (
D,
fig.2
) so the red dot is down.(
fig.7
)
Put the contact tip (
A, fig.2
) of the tool on the
working surface
Lightly push the tool toward the working surface
until the safety bracket is depressed
Press the trigger (
E, fig.2
) to drive the fasteners.
This “trigger fire” method provides the most
accurate fastener placement.
2.
Bump Fire:
Push in, then turn the trigger mode selector (
D,
fig.2
) so the red dot is up.(
fig.7
)
Hold the contact tip (
A, fig.2
) off the surface
Press the trigger
Keeping the trigger pressed, push the contact tip
(
A, fig.2
) of the safety bracket against the working
surface. Once the bracket is pushed back enough,
the nail will fire.
CAUTION:
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving
working area, moving tool to another location or
handing the tool to another person.
Clean and inspect tool daily. Carefully check for
proper operation of trigger and safety mechanism.
Do not use the tool unless both the trigger and the
safety mechanism are functional.
Do not use the tool if its leaking air or needs any
other repair.
FASTENER DEPTH
Driving depth can be adjusted by rotating the depth
adjustment knob (
B, fig.2
).
Test fire a fastener into a scrap work piece and
check depth.
n
n
n
n
n
n
n
n
n
OPERATING PROCEDURES
