Series UAG
Page 18
Nov 11, 2015
Couplings
Hanger
Location
Hanger
Location
Assemble Corner Bracket
to Mitered Reflectors as shown
Mitered Reflector
Sections should
overlap standard
Reflectors.
Fasten Mitered Reflectors
with 4 - #8 x 3/8" Screws
CR039
CT010
Installation
E
LBOW AND
“U-T
UBE
”
I
NSTALLATION
•
If required by the heater layout, install 90° elbows or U-tube where indicated. Refer to Figure 15
& 16 for details.
Note:
Elbows or U-tubes are installed with reflectors. You must use mitered reflector
kit(s) to do so.
Figure 15: 90° Elbow Assembly Detail
•
Elbows or U Tubes must be located not less than 10' from the burner.
