Series UAG
Page 17
Nov 11, 2015
Installation
Note:
Reflectors should overlap adjacent reflectors 4" to 6". Be sure not to tile reflector sections;
that is, reflector sections must be either above both adjacent reflector sections, or below both
adjacent reflector sections..
Secure every second reflector overlap together with a minimum of 2 - #8 x 3/8" inch long screws
(not supplied), and secure reflector to the reflector bracket at this point by tightening down #8 x
1¼" screws supplied with reflector brackets (Figure 14). The remaining reflector overlap joints
and reflector brackets are left loose to accommodate system movement.
Reflector
Support
Loose
Screws
Tight
Screws
Loose
Screws
Tight
Screws
Reflector Overlap
Approx. 6"
Vent
Termination
End
Insert End Cap into
Reflector and Secure
it with #8 x 3/8" Screws
Note:
Close all chain links "S" hooks, "J" bolts
and turnbuckles or any open connection
.
Secure every SECOND reflector
overlap with a minimum of 2
#8 x 3/8" long screws
on each side
Loose Screws
Figure 14: Reflector Overlap Illustration
