Operation
900684-01 06/2018
Innovative Hearth Products
DRT3000 Series Direct-Vent Gas Fireplaces
53
If the millivolt fireplace is equipped with an optional remote switch (wall switch, remote control, rocker switch, or
wall thermostat) and the pilot is lit, the fireplace main burner can be turned ON/OFF using the optional switch.
NOTE:
Do NOT wire more than one valve to the burner control switch. This will help prevent excessive resistance in
the burner circuit, that can cause burner operation problems.
Electronic Fireplaces
Detailed lighting instructions are found on
Pages 69-70
. Also, electronic fireplace lighting instructions are found on
the pull-out lighting instructions attached to the gas control valve.
If the electronic fireplace is equipped with an optional remote wall switch or remote control, the fireplace main
burner can be turned ON/OFF with the wall switch or remote control.
If the electronic fireplace is not equipped with a wall switch or remote control, the main burner must be turned ON/
OFF with a gas control switch installed separately. Contact the installer for more information. Check the batteries, if
installed, at least every three (3) months to ensure they are properly charged.
To light the fireplace in a power outage:
1.
Confirm that batteries are installed in the battery pack.
2.
Set the unit-mounted switch, or wall switch to the ON Position.
3.
The unit should spark at the pilot and light.
NOTE:
If there is no spark turn unit to off position, replace the
batteries, and repeat steps 1-3 above.
4.
Operate the fireplace normally.
Installing the Backup Batteries
With a battery backup, electronic fireplaces can automatically switch to battery power. In the event of a power outage, this
allows ON/OFF operation (without blower functionality). Install new batteries before every burn season.
1.
Open the control compartment
(
Page 52
)
, and locate the battery holder.
2.
Install four (4) AA batteries in the battery holder.
3.
Close the control compartment door.
Some parts have been removed for clarity
Battery Holder (in control compartment)
Switches (in control compartment)
Battery
Holder
Learn Switch is for programming the remote (see
instructions provided with the remote control)
IPI Switch is for continuous pilot or standing pilot
Hi-Low Switch controls the main burner flame height
ON/OFF Switch turns the burner on and off
