Operation
900684-01 06/2018
Innovative Hearth Products
DRT3000 Series Direct-Vent Gas Fireplaces
57
Installing 40” and 45” logs
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log
placement is critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the
flames. Follow the log placement instructions precisely.
NOTE:
Do not cover the burner ports.
40” and 45” Log Sets
Log Number
Description
1
Rear Log
2
Left Front Log
3
Right Front Log
4
Left Cross Log
5
Right Cross Log
NOTE: Fireplace shown with optional brick panels and volcanic stone.
1.
If necessary, remove the glass door
(
Page 58
)
. Locate and bend up the log placement brackets
(
Figure 54
).
Figure 50 - Locating the log placement brackets
Figure 51 - Placing logs 1 and 2a
2.
Position rear left log (1) on the left rear log bracket
(
Figure 55
)
3.
Position the left front log (2) and the right front log (3) against the log rack
(
Figure 55
)
.
Figure 52 - Placing log 2b
Figure 53 - Placing log 5
4.
Position the left cross log (4) over the rear log (1) and left front log (2) with the front resting on the log rack
(
Figure 56
)
.
5.
Position the right cross log (5) on the right rear log bracket and over right front log (3)
(
Figure 57
)
.
NOTE
: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot flame is not
obstructed. See Verifying Appliance Operation on
Page 42
.
Catalog number for the entire set:
F1830
-
40” Models
F1884
-
45” Models
4
5
3
2
1
Glowing Embers
(Do not place glowing embers over burner slots)
Right Rear Log Bracket
1
Volcanic Stone
Log Rack
3
2
4
2
1
3
5
