Specification of excellent controller
Page - 5 -
①
--- Wiring connection with system terminals
②
--- LCD with green backlight
③
--- ▲(+) setting key to increase value of parameters.
④
--- ―Esc‖ key for existing system without save setting.
⑤
--- ▼(-) setting key to reduce value of parameters.
⑥
--- ―Enter‖ key to process setting condition or save modification of
parameters.
8. Installation Instructions
8.1 General Installation Notes
Read through the entire installation section first before beginning installation.
Be very careful when working with batteries. Wear eye protection. Have fresh
water available to wash and clean any contact with battery acid.
Uses insulated tools and avoid placing metal objects near the batteries.
Explosive battery gasses may be present during charging .Be certain there is
sufficient ventilation to release the gasses.
Avoid direct sunlight and do not install in locations where water can enter the
controller.
Loose power connections and /or corroded wires may result in resistive
connections that melt wire insulation, burn surrounding materials, or even
cause fire. Ensure tight connections and use cable clamps to secure cables and
prevent them from swaying in mobile applications.
Use with Gel, Sealed or Flooded batteries only.
Battery connection may be wired to one battery or a bank of batteries. The
following instructions refer to a singular battery, but it is implied that the
battery connection can be made to either one battery or a group of batteries in
a battery bank.
Select the system cables according to 3A/mm²
current density.
8.2 Mounting
NOTE: When mounting the controller, ensure free air through the
controller heat sink fins. There should be at least 150mm of clearance above and
below the controller to allow for cooling. If mounted in an enclosure, ventilation
is highly recommended.
WARNING: Risk of explosion! Never install the controller in a
sealed enclose with flooded batteries! Do not install in a confined area
where battery gas can accumulate.
