28
Note that proper placement of the probe is essential to the accuracy of the
measurement.
6.
After 10-15 seconds, a long beep signals the end of the measurement. The result will
be displayed for two minutes or until you initiate a new measurement.
7.
Remove the probe, discard the probe cover and place back in the probe holder. Note
the reading.
If the temperature reading is out of range, the device will beep and flash the
limit that is exceeded. So, if the reading is greater than 109.4°F (43.0°C),
“109.4” or “43.0” will flash on the display followed by a sequence of rising
LED’s. If the reading is less than 86.0°F (30.0°C), “86.0” or “30.0” will flash
on the display followed by a sequence of falling LED’s.
Summary of Contents for ADC ADview 9000BP
Page 2: ...ii...
Page 80: ...69 IB p n 93 9000UM 00 rev 4...