19
1.
For blood pressure measurements, the blood pressure hose should already be
attached to the BP device. If not, push the open end of the blood pressure hose (one
without the plastic connector) over the blood pressure hose connector on the
module. Secure the end with the plastic connector to an appropriately sized cuff by
twisting the two mating connectors together.
2.
For temperature measurements, remove the tape holding the temperature probe in
the well, and place the box of probe covers in the well next to the probe.
3.
For SpO
2
measurements, attach the pulse oximetry cable into SpO
2
connector port in
the module and flip the retention clip forward to locking position.
4.
Connect the power supply to the main BP module. Then, connect the power supply
to an AC mains power source. The device will turn on automatically.
Powering Up
Powering Up
Powering Up
Powering Up
1.
Depress the power button located on the right side of the main enclosure. The
power-up sequence begins. All display segments light up for three seconds. A short
beep indicates that the
ADview
is ready.
2.
Check the status of the power level indicator. If the power level indicator shows one
segment flashing, connect the device to the power supply before using. You are now
ready to use your
ADview
.
Selecting Temperature Unit of Measurement
With the device powered on, select the unit of measurement for temperature by depressing
the recessed button on the side of the temperature module to toggle between the °C and °F
icons. The selected icon will be lit in the display and becomes your default selection.
Bluetooth Wireless Communication
If your
ADview
has the optional Bluetooth wireless communication capability, please contact
your IT administrator for configuration with your EMR/EHR system or communication
network.
Summary of Contents for ADC ADview 9000BP
Page 2: ...ii...
Page 80: ...69 IB p n 93 9000UM 00 rev 4...